Hose-to-Hose Safety Whip Check

Hose-to-Hose Safety Whip Check

from 13.19

Spring wire hose safety whip checks are the industry standard in low pressure air compressor hose safety.  Install at each connection from the tool to the supply source. The end loops retract to hold snug against varying hose diameters.

  • 200 PSI air service rating
  • 5X safety ratio (1000 PSI burst)
  • Galvanized or 304 Stainless Steel 

CABLE DIMENSIONS

  • 1/2" to 1-1/4" Model:  1/8" Cable, 20" Length
  • 1" to 2" Model:  3/16" Cable, 28" Length
  • 1-1/2" to 3" Model:   1/4" Cable, 38" Length
  • 4" Model:   3/8" Cable, 44" Length

NOTE: REPLACE AND DISCARD IF A BLOWOUT EVENT OCCURS

Always install fully extended with no slack, with the cable centered on the hose connection when possible.

Hose ID Range:
Material:
Quantity:
I'll Take it

Photos showing gold colored ferrule are stainless steel model with bronze ferrule.  Standard material is galvanized steel with aluminum ferrule.

for additional information please visit www.capitalrubber.com/hose-safety-whip-checks

WARNING: Cancer and reproductive harm: www.P65Warnings.ca.gov

MSHA & OSHA Requirement Statements:
MSHA 30 CFR § 56.13021.
High-pressure hose connections
Except where automatic shutoff valves are used, safety chains or other suitable locking devices shall be used at connections to machines of high-pressure hose lines of 3/4-inch inside diameter or larger, and between high-pressure hose lines of 3/4-inch inside diameter or larger, where a connection failure would create a hazard.
OSHA 29 CFR § 1926.302(b)(1)
Pneumatic power tools shall be secured to the hose or whip by some positive means to prevent the tool from becoming accidentally disconnected.
This product is not directly approved, endorsed, or certified by MSHA or OSHA, however it is designed to meet the requirements of these organizations