Center Punch Hose Clamps
Center Punch Hose Clamps
from $68.26
Center Punch Hose clamps allow for a professional, repeatable assembly and on-site hose repair. Available in galvanized steel or 300 stainless steel. Size shown is the actual clamp diameter. Order so the clamp can fit over the outside diameter of the hose. (Typically 1/2 to 1 inch larger than inside diameter, but may vary by hose style).
Installation tool is required
Prices are per carton
Carton quantity is shown below photos
All clamp widths are 5/8 unless noted in the diameter
Clamp Diameter:
Material:
Quantity:
1" THROUGH 2-1/4" CLAMPS ARE 100 PER CARTON
2-1/2" THROUGH 3-1/2" ARE 50 PER CARTON
4" THROUGH 8" ARE 25 PER CARTON
(ORDER QUANTITY 1 = 1 CARTON)
WARNING: Cancer and reproductive harm: www.P65Warnings.ca.gov
The center punch hose clamp tool is used to apply preformed center punch style hose clamps. First insert the tail of the preformed hose clamp into the tool, then crank the tool to cinch the clamp down tight against the hose. The punch clamp is designed to permanently seal when the punch on the tool is hit against the hose clamp's buckle. Then roll the clamp tool upward to break free from the hose clamp. The tail end of the hose clamp can then be removed from the tool and recycled.
Clamp pressure is not measured in this system. Test the hose and monitor during use to ensure proper tension.
Click for compatible center punch type clamps. Not for use with bulk band and buckle, roll-over style, or open-ended clamps