Hose Cable Choker Restraints offer safety for higher pressure hose failures
Significantly reduce the hazards of an unchecked pressurized hose during a failure incident or accidental disconnection with one easy-to-install device
Hose Cable chokers are designed for hose applications where a pressure rating beyond the hose whip checks is required. These safety restraints can withstand several thousand pounds of pressure (dependent on cable and hose diameter). The unique design utilizes a nylon spool at each loop-end that allows the cable choker to cinch tighter around an unchecked hose. This not only holds the hose in place, but can also significantly decrease or stop flow completely until the pressure can be relieved at its source. Each cable choker comes tagged from the factory with their fluid and gas (air) ratings. Due to the hazards and force of air and gas applications, the maximum working pressure rating for these applications is reduced to half of the fluid rating.
Hose cable chokers range from 3/32 cable up to 1/2 inch cable, for a hose inside diameter range from 1/4 up to 8 inch (see static load vs size chart below).
Custom cables can be fabricated to your specific application for increased pressure rating, abrasion resistance, or the connection of varying sizes of hose.
Models are available for frac hose and other high pressure lay-flat discharge hose up to 12 inch hose inside diameter.
Due to the high pressure ratings and the customized length and end loop options, this product is quoted by inquiry only.
Please call or email us with your specific application details for additional information.
We will need the following information: Hose diameter, working pressure, media (fluid, gas, air) end coupling type, quantity, and any other application details that should be taken into consideration. Do not consider hose working pressure as static load. The chart shown only depicts the load capabilities of each choker cable diameter. Please allow us to determine the appropriate cable based on your hose working pressure and specific application details.
Please contact us by email or phone with your application details and we will gladly offer quotation.
Also consider our other safety restraint products including Whip Stop safety restraints for high pressure applications
WARNING: Cancer and reproductive harm: www.P65Warnings.ca.gov
Be safe and stay within regulation and code. This product when installed properly meets the following:
Meets OSHA29 CFR 1926.603 paragraph (a)(10)
OSHA 29 CFR 1926.302(b) (1)
US Army Corps of Engineers 13.G.02
MSHA 30 CFR §56/57.13021
MSHA 30 CFR §75.1730
United States Bureau of Reclamation 17.2.2
Canadian Centre for Occupational Health & Safety
Please check directly with all regulating agencies pertaining to your job site or workplace to verify the most up to date hose safety rules and regulations.
This product is not directly approved, endorsed, or certified by MSHA or OSHA, however it is designed to meet the requirements of these organizations